Glass Cold Working Equipment

The 3M EverRun Diamond Band kits contain one each of 60 grit, 120 grit, 200 grit, 400 grit, and 800 grit along with one each of 3/32 inch and 1/8 inch shank rubber drums for mounting the bands.

Crystalite's Triple Ripple Diamond Drills are a three fluted diamond wire drill made specifically for drilling smaller holes in your glass for threading wire or other smaller material through. They are very efficient and can be used in either a Dremel or Flexible Shaft or Drill press for accurate drilling. For typical 1/8 inch glass you can expect to drill about 25-30 holes per drill.

3M's thin diamond strips are 3/4 inch by 7 inch Velcro backed electroplated diamonds that can be used with a hard plastic file for surface and edge sanding or wrapped around fingers or other tools to get into hard to reach areas for grinding of your glass surfaces. The diamond strip set contains one each of 60 grit, 120 grit, 200 grit, and 400 grit. It also contains one 3/4 inch x 11 inch plastic file blank with Velcro.

Sintered diamond points have a 1/8 inch steel shank and a shaped head that has diamond all the way through the head. This gives a longer lasting diamond point with a more consistent grinding finish each time you use it. You must be careful to use these points with water so you don't overheat the point head and destroy the diamond or strip it off the shaft.

Sintered diamond points have a 1/8 inch steel shank and a shaped head that has diamond all the way through the head. This gives a longer lasting diamond point with a more consistent grinding finish each time you use it. You must be careful to use these points with water so you don't overheat the point head and destroy the diamond or strip it off the shaft.

Sintered diamond points have a 1/8 inch steel shank and a shaped head that has diamond all the way through the head. This gives a longer lasting diamond point with a more consistent grinding finish each time you use it. You must be careful to use these points with water so you don't overheat the point head and destroy the diamond or strip it off the shaft.

Sintered diamond points have a 1/8 inch steel shank and a shaped head that has diamond all the way through the head. This gives a longer lasting diamond point with a more consistent grinding finish each time you use it. You must be careful to use these points with water so you don't overheat the point head and destroy the diamond or strip it off the shaft.

Sintered diamond points have a 1/8 inch steel shank and a shaped head that has diamond all the way through the head. This gives a longer lasting diamond point with a more consistent grinding finish each time you use it. You must be careful to use these points with water so you don't overheat the point head and destroy the diamond or strip it off the shaft.